2005 HF Series User’s Manual
112505.0959
12
SWITCH ON / OSD
SWITCH ON / OSD
WELCOME MESSAGE
>
SWITCH ON CHANNEL
TV 2
SWITCH ON VOLUME
30
SWITCH ON PIC FMT
WIDESCREEN
POWER ON
STANDBY
VOLUME INDICATOR
YES
CHANNEL DISPLAY
ALL
3 DIGIT ENTRY
NO
•
WELCOME MESSAGE:
A welcome message (two lines, 20 characters) can appear on-screen when the set is
powered on. The message remains on-screen until the TV receives a command from
the remote or front panel or times out in 25 seconds. When the WELCOME
MESSAGE setup menu item is highlighted, cursor right or left to invoke the
MESSAGE sub- menu. Cursor up or down to select the desired MESSAGE sub- menu
item. Press MENU to return to the SETUP main menu.
•
SWITCH ON CHANNEL:
TV 1-TV 125/HDMI 1/HDMI 2/SIDE AV/AV 1/AV 2/
/ STANDARD)
Specify the channel / input to which the TV will be tuned when it is powered on.
If STANDARD, the channel at power-on will be that to which the TV was tuned at
last power-down. If specified (e.g., 2, AV1, etc.), then that will always be the channel
/ input at power-on, until SWITCH ON CHANNEL is changed.
•
SWITCH ON VOLUME:
(STANDARD / 0 - 99)
Specify the volume setting that takes effect when the TV is powered on.
If STANDARD, the volume at power-on will be the volume at which the TV was
prior to last power-down.
If specified as 0 - 99, that will always be the volume at power-on, until SWITCH ON
VOLUME is changed.
•
POWER ON:
(STANDBY / FORCED ON)
STANDBY:
The TV will be in standby mode when AC mains power is first
applied after having been disconnected.
FORCED ON:
The TV will turn ON whenever AC mains power is applied. This
feature allows the TV’s power status to be controlled, for example, from an AC mains
breaker. In addition, the set cannot be put into standby with a guest remote or using
the front panel power key.
•
VOLUME INDICATOR:
(NO / YES)
When VOLUME INDICATOR is set to YES, an OSD graphic appears that provides
visual verification (e.g. “VOLUME 15”) during volume adjustment, by means of
either the remote control, or the front panel (if it is not locked out).
•
CHANNEL DISPLAY:
(NONE / NUMBER / LABEL / ALL)
Specifies which of the respective channel properties are displayed by the TV’s OSD
when a channel or input is first selected.
•
3 DIGIT ENTRY:
(NO / YES)
o
YES: The TV, upon receiving a remote control digit command, “expects” to
receive up to two more successive remote control digit commands (e.g. 123,
012, etc.) before tuning the intended channel. The television will display, in
