Mechanical Instructions
4.
4.4.3
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1.
Gently unplug all connectors from the PSU.
2.
Remove all fixation screws from the PSU.
3.
The PSU can be taken out of the set now.
4.4.4
Speakers
1.
Gently release the tapes that secures the speaker cables.
2.
Unplug the speaker connectors from the SSB.
3.
Take the speakers out.
When defective, replace the both units.
4.4.5
Keyboard Control unit
1.
Unplug the connector from the keyboard control panel.
2.
Gently push inwards the two clips at the PSU side of the
unit. Release the unit at the PSU side and turn it away from
the PSU. Now push it towards the PSU to release the
catches at the other side of the unit. Take it out from the
metal bracket.
When defective, replace the whole unit.
4.4.6
Stand bracket
1.
Remove all fixation screws of the bracket.
2.
Lift the bracket from the set.
4.4.7
IR/LED Panel
1.
Remove the stand bracket, as described earlier.
2.
Unplug the connector from the IR/LED panel.
3.
Gently release the clip that holds the panel and take it out
from the bezel.
When defective, replace the whole unit.
4.4.8
LCD Panel
1.
Unplug all the connector cables of the boards.
2.
Gently take all the speakers out.
3.
Lift the subframe with SSB, PSU, IR/LED panel from the
LCD panel and put it aside.
Warning:Cause the panels of 22HFL3008 and 24HFL3008 are
bolt-on panels, the panel could not release from bezel.
When defective, replace the whole unit.
4.5
Assembly/Panel Removal ( for 26")
Instructions below only apply to the 26HFL3008W/12, but will
be similar for 26HFL3008D/12 model.
4.5.1
Rear Cover
Refer to
for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1.
Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [2] that secure the rear cover. Refer to
for details.
2.
At the indicated areas [3] the cover is secured by clips. Be
very careful with releasing those.
3.
Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
