Mechanical Instructions
4.
Figure 4-10 Rear cover removal
4.5.2
Small Signal Board (SSB)
Refer to
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Release the clips from the LVDS connector that connect
with the SSB [1].
Caution: be careful, as these are very fragile connectors!
2.
Unplug all other connectors [2] and the FFC connector [3].
3.
Remove all the fixation screws from the SSB [4].
4.
The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
for details.
Figure 4-11 SSB removal
19461_106_131202.eps
131202
3
3
1
1
2
2
2
2
2
2
2
19461_107_131202.eps
131202
2
1
3
4
4
4
4
