Mechanical Instructions
EN 8
TE3.2E CA
4.
4.
Mechanical Instructions
Index of this chapter:
4.1 Rear Cover Removal
4.2 Service Position Main Panel
4.3 Rear Cover Mounting
Note: Figures below can deviate slightly from the actual
situation, due to the different set executions.
4.1
Rear Cover Removal
•
Remove all (ten) fixation screws of the rear cover: two at
the top, two at each side, three at the bottom and one in
the middle of the rear cover. The 14" set has only four
fixation screws: two at the top and two at the bottom.
•
Now pull the rear cover backward to remove it.
4.2
Service Position Main Panel
•
Disconnect the strain relief of the Mains cord.
•
Remove the main panel, by pushing the two centre clips
outward [1]. At the same time, pull the panel away from the
CRT [2].
•
Disconnect the degaussing coil by removing the cable from
connector KP02.
•
Move the panel somewhat to the left and flip it 90 degrees
[3], with the components towards the CRT.
4.3
Rear Cover Mounting
Before you mount the rear cover:
•
Place the mains cord correctly in its guiding brackets
(strain relief).
•
Place all cables in their original position.
Figure 4-1 Mechanical Service Position
1
1
2
A
3
B
G_16010_010.eps
130206