Mechanical Instructions
EN 7
SHA2.0U LA
4.
4.3
Assy/Board Removal
4.3.1
DVD Assy
Warning:
Disconnect the AC Power cord before you open the
set.
1.
Place the TV set upside down on a table top, using the
foam bars (see part "Foam Bars").
Caution:
do
not
put pressure on the display, but let the
monitor lean on the the Front cover.
2.
Remove all screws from the DVD Assy.
3.
Then, disconnect the cables from the DVD Assy.
4.
Lift the DVD Assy from the set.
4.3.2
Rear Cover
1.
Remove the screws that secure the rear cover.
2.
Disconnect the cable from the TVK board. Lift the rear
cover from the cabinet.
4.3.3
Main Board Figure 4-4 (1)
1.
Disconnect the cable from the Main board.
2.
Remove the fixation screws.
3.
Take out the Main board.
4.3.4
Power Board Figure 4-4 (2)
1.
Disconnect the cable from the Main board.
2.
Remove the fixation screws.
3.
Take out the Power board.
4.3.5
RMC Board Figure 4-4 (3)
Figure 4-4 TV disassembly
1
1
3.
Remove the screws that secure the main board shield cover.
The screws are located at the top, bottom, left and right
sides. Make sure that wires are not damaged during removal.
1.
Disconnect the cable from the RMC board.
2.
Remove the fixation screws.
3.
Take out the RMC board.
4.3.7
HV Power Board Figure 4-5 (1)
1.
Remove the screws that secure the LCD TFT shield cover.
The screws are located at the top, bottom, left and right
sides.
2.
Disconnect the cable from the LCD TFT. Remove the
screws that secure the HV power board. Lift the HV
power board from the LCD TFT shield cover.
4.3.6
IF Board Figure 4-4 (4)
1.
Disconnect the cable from the IF board.
2.
Remove the fixation screws.
3.
Take out the IF board.
4.3.8
LCD TFT Figure 4-5 (2)
Important:
Be sure to work in a dust free environment during
the following activities. In addition, the use of (fabric) hand
gloves is advised.
3
4
2
1
2
1
2
2
Figure 4-5 TV disassembly
4.3.9
DVD Top Cover Figure 4-6 (1)
1.
Remove the screws that secure the DVD top cover.
Make sure that wires and flat foils are not damaged
during removal.
2.
Disconnect the cable from the DVD key board. Lift the
DVD top cover from the cabinet.
1
1
Figure 4-6 DVD disassembly
4.3.10
DVD Power Board Figure 4-7 (1)
1.
Disconnect the cable from the DVD power board.
2.
Remove the fixation screws.
3.
Take out the DVD power board.
4.3.11
DVD Out Board Figure 4-7 (2)
1.
Disconnect the cable from the DVD out board.
2.
Remove the fixation screws.
3.
Take out the DVD out board.
4.3.12
DVD Loading Assy Figure 4-7 (3)
1.
Disconnect the cable from the DVD loading Assy.
2.
Remove the fixation screws.
3.
Take out the DVD loading Assy.
