7
OSD Lock/Unlock, Aging Mode
To Lock/Unlock OSD function (User Mode)
The OSD function can be locked by pressing "OK" button(1) for more
than 10 seconds, the screen shows following windows for 3 seconds.
Everytime when you press "AUTO" or "OK" button, this message
appears on the screen automatically.
Unlock OSD function:
Locked OSD function can be released by pressing"OK" button for
more than 10 seconds again.
Turn off LCD monitor, and disconnect Interface Cable
After 15 seconds, bring up :
After 15 seconds, bring up :
----------
----------
repeatly
Connect signal cable again => go back to normal display.
" buttons at the same time and hold
" button untill comes out "AGING screen"
] => then release all buttons.
A G I N G ...
A G I N G ...
Front control panel
Fig. 1
NO VIDEO INPUT
This screen appears if there is no video signal input. Please check
that the signal cable is properly connected to the video card of PC
and make sure PC is on.
ATTENTION
NO VIDEO INPUT
WAITING FOR AUTOMATIC ADJUSTMENT
CANNOT DISPLAY THIS VIDEO MODE..
This screen warns when the input frequency from the computer is not
a standard video mode or out of the monitor's scanning range.
Please change the display mode of the operating software in the
computer(i.e. Windows) to 1024 x 768@ 60Hz for best display results.
This screen appears when you press the
buttons at the
same time . It will disappear when the monitor is properly adjusted.
ATTENTION
CANNOT DISPLAY THIS VIDEO
MODE, CHANGE COMPUTER DISPLAY
INPUT TO
@60HZ
1024 x 768
150S5
Содержание 150B5CB/27
