2
Important for the United Kingdom
This apparatus is fitted with an approved moulded 13 Amp
plug. To change a fuse in this type of plug proceed as follows:
1
Remove fuse cover and fuse.
2
Fix new fuse which should be a BS1362 5A, A.S.T.A. or BSI
approved type.
3
Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should
be cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of
5A. If a plug without a fuse is used, the fuse at the distribution
board should not be greater than 5A.
Note: * The severed plug must be destroyed to avoid a
possible shock hazard should it be inserted into a 13A
socket elsewhere.
How to connect a plug:
The wires in the mains lead are coloured in accordance with
the following code:
BLUE - ’NEUTRAL’ (’N’)
BROWN - ’LIVE’ (’L’)
1
The BLUE wire must be connected to the terminal which is
marked with the letter ’N’ or coloured BLACK.
2
The BROWN wire must be connected to the terminal
which is marked with the letter ’L’ or coloured RED.
3
Do not connect either wires to the earth terminal in the
plug which is marked with the letter ’E’ or by the safety
earth symbol
\
or coloured green or green-and-
yellow.
Before replacing the plug cover, make certain that the cord
grip is clamped over the sheath of the lead - not simply over
the two wires.
Connecting the cables
1
Insert the aerial plug into the
2
socket.
If you use the auxiliary aerial supplied, push the aerial into the
mounting on the back panel until it snaps into place.
Pull out the telescopic rod(s) as far as required. Tilt and rotate
the aerial until you have got the best picture quality.
2
Insert the plug of the mains cable into the wall socket.
3
Switch the set on. The power switch
8
is located on
the left side panel of the set.
Important notes for operation
•
We advise you, from now on, to switch the set to standby
using the
STANDBY
m
button on the front of the set or on
the remote control.
•
When the set is in the standby mode, a small red lamp on
the left of the front of the set will be alight.
•
You can switch on with the
STOP
h
button, the
0-9
buttons or by inserting a cassette.
•
Attention:
When you use the power switch
8
on the
side panel, you have
completely
switched off the set from
the mains power supply. No programmed recordings will
then be made. The red lamp on the left of the front of the
set will not be alight. After a few hours, the date and clock
settings will be lost.
•
Attention:
Before you switch off the appliance with the
power switch
8
, remove the tape by pressing the
J
button.
•
Keep your TV Combi connected to the mains and the
power switch in ’on’ position at all times to ensure that
programmed recordings can be made and that the
television functions normally. The power consumption
required is low.
•
Back-up power supply: TV channel storage - typically 1
year, Clock/Timer - typically 30 hours.
1.
INSTALLATION
