IMPORTANT:
Always activate a moving screen saver program when you leave your monitor unattended.
Always activate a periodic screen refresh application if your monitor will monitor unchanging static
content. Uninterrupted monitor of still or static images over an extended period may cause
“
burn
in
”
, also known as
“
after-imaging
”
or
“
ghost imaging
”
, on your screen.
“
Burn-in
”
,
“
after-imaging
”
, or
“
ghost imaging
”
is a well-known phenomenon in LCD panel technology.
In most cases, the
“
burned in
”
or
“
after-imaging
”
or
“
ghost imaging
”
will disappear
gradually over a period of time after the power has been switched off.
Warning
Severe
“
burn-in
”
or
“
after-image
”
or
“
ghost image
”
symptoms will not disappear and
cannot be repaired. The damage mentioned above is not covered under your warranty.
Service
* The casing cover should be opened only by qualified service personnel.
* If there is any need for any document for repair or integration, please contact with your local
service center. (Please refer to the chapter of
“
Consumer Information Center
”
)
* For transportation information, please refer to
“
Technical Specifications
”
.
* Do not leave your monitor in a car/trunk under direct sun light.
Note
Consult a service technician if the monitor does not operate normally, or you are not sure what
procedure to take when the operating instructions given in this manual have been followed.
Europe – EU Declaration of Conformity
This device complies with the requirements set out in the Council Directive on the Approximation
of the Laws of the Member States relating to Electromagnetic Compatibility (2014/30/EU), Low-
voltage Directive (2014/35/EU), RoHS directive (2011/65/EU), and Radio Equipment Directive
(2014/53/EU).
This product has been tested and found to comply with the harmonized standards for Information
Technology Equipment, these harmonized standards
Radio Equipment Directive (2014/53/EU): EN60950-1/EN62311/EN300328/EN301489
Warning:
This equipment is compliant with Class A of EN55032. In a residential environment this equipment
may cause radio interference.
ESD Warnings:
When user close to the monitor may cause the equipment discharge and reboot to monitor of main
menu.
