NO
.
Name
Def.
Valid
Description
2 Basic Set
Level
-1
All
Setting the BASIC command value to turn on
the light. -1(0xFF) means turn on the light.
For dimmer equipment 1 to 100 means the
light strength.
0 means turn off the light.
Caution
: The range is from 0x00~0xFF
using hexadecimal notation.
3
(*)
PIR
Sensitivity
80
0 ~ 99
PIR sensitivity setting.
0 means disable the PIR motion.
1 means the lowest sensitivity,
99 means the highest sensitivity.
High sensitivity means can detected long
distance, but if there is more noise signal in
the environment, it will re-trigger too
frequency.
6
(*)
Mult-
Sensor
Function
Switch
5
All
Multisensor function switch. Using bit to
control.
Caution
: The range is from 0x00~0xFF
using hexadecimal notation.
0
Bit0
: Reserve.
0
Bit1
: Reserve.
1
Bit2
: Reserve.
0
Bit3
: When Bit2 is 0 (Enable), Are the device
and the lighting in the same room?
0: In the same room(Default),
1: In the different room.
Notice
: If this bit is 1, it is recommended
also set the Bit1 to 1, cause the PIR
triggered, doesn't mean the people in that
room.
NO
.
Name
Def.
Valid
Description
0
Bit4
: Disable delay 5 seconds to turn off the
light, when door/window closed. (1:Disable,
0:Enable)
0
Bit5
: Disable auto turn off the light, after
door/window opened to turn on the light.
(1:Disable, 0:Enable)
Notice:
If bit2 is zero, this setting is useless.
Notice:
If the configuration No.9 is zero,
this setting is useless.
0
Bit6
: Reserve.
0
Bit7
: Reserve.
7
(*)
Customer
Function
4
All
Customer function switch, using bit control.
Caution
: The range is from 0x00~0xFF
using hexadecimal notation.
0
Bit0
: Reserve.
0
Bit1
: Enable sending motion OFF report.
(0:Disable, 1:Enable)
Note
: Depends on the Bit4,
0: Report Notification CC,
Type: 0x07, Event: 0xFE
1: Sensor Binary Report,
Type: 0x0C, Value: 0x00
1
Bit2
: Enable PIR super sensitivity mode.
(0:Disable, 1:Enable)
0
Bit3
: Reserve.
0
Bit4
: Notification Type,
0: Using Notification Report.
1: Using Sensor Binary Report.
6
