Motion Sensor PSP05
PSP05-A PSP05-B
PSP05-C PSP05-D
The motion sensor PSP05 has PIR function, based on Z-Wave
TM
technology.
This device is a Security Enabled Z-Wave Plus Product. Z-Wave
TM
is a
wireless communication protocol designed for home automation,
specifically to remotely control applications in residential and light
commercial environments. The technology uses a low-power RF radio
embedded or retrofitted into home electronics devices and systems,
such as lighting, home access control, entertainment systems and
household appliances.
This product can be included and operated in any Z-Wave
TM
network
with other Z-Wave
TM
certified devices from other manufacturers and/or
other applications. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the
network.
The device adopt the Z-Wave
TM
500 series chip, when your Z-Wave
TM
network system is all made by Z-Wave
TM
500 series devices. The
network system will have the advantages as below.
•
Concurrent multi-channel support reduces external interference.
•
Better RF range, improve about 10 meters in indoor.
•
Support 100 Kbps transmit speed, speed up communication.
Add to/Remove from Z-Wave
TM
Network
There are two keys in the device, one is tamper key, another is a
button. Button can add, remove, reset or association from Z-Wave
TM
network.
In the first time, add the device into the Z-Wave
TM
network. First, make
sure the primary controller is in the add mode. And then power on the
device, just take out the insulation Mylar in the back side of the device.
The device will auto start the NWI (Network Wide Inclusion) mode. And
it should be included in 5 seconds. You will see the LED light ON one
second.
1
