Notification Report (V4)
Notification Type: Access Control (0x06)
Event: Door/Window is open (0x16)
Door/Window is closed (0x17)
lock tongue is lock (0x01)
lock tongue is unlock (0x02)
Z-Wave Configuration Settings
A
B
NO.
Name
Default
Valid
Description
1
Auto
report
state time
12
0 ~ 127 The interval time for auto
report the door/window &
Lock state & battery level.
0 means turn off auto
report state.
Units of 30 minutes.
2
Door lock
detect
function
switch
1
0~1
0 means turn off Door
lock detect funtion.
1 means turn on Door
lock detect funtion.
3
Door lock
detect
timer
15
1~127
Units of
4
seconds.
4
Door lock
detect
level
10
1~10
When an error condition
occurs in the door lock
detection.
Can reduce its level to
avoid door lock detection
errors.
Notice:
* All of the configuration, the data size is 1.
* The configuration mark with star(*), means after the remove the setting still
keep, don't reset to factory default. Unless the user execute the “RESET”
procedure.
* The reserve bit or not supported bit is allowed any value, but no effect.
Security Network
The device supports the security function. When the device included with a
security controller, the device will auto switch to the security mode. In the
security mode, the follow commands need using Security CC wrapped to
communicate, otherwise it will not response.
COMMAND_CLASS_ZWAVEPLUS_INFO
COMMAND_CLASS_SUPERVISION
COMMAND_CLASS_WAKE_UP
COMMAND_CLASS_CONFIGURATION
COMMAND_CLASS_TRANSPORT_SERVICE_V2
COMMAND_CLASS_SECURITY
COMMAND_CLASS_SECURITY_2
COMMAND_CLASS_VERSION
COMMAND_CLASS_ASSOCIATION
COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V2
COMMAND_CLASS_ASSOCIATION_GRP_INFO
COMMAND_CLASS_MANUFACTURER_SPECIFIC
COMMAND_CLASS_DEVICE_RESET_LOCALLY
COMMAND_CLASS_POWERLEVEL
COMMAND_CLASS_BATTERY
COMMAND_CLASS_NOTIFICATION_V3
COMMAND_CLASS_FIRMWARE_UPDATE_MD_V4
Over The Air Firmware Update
The device support the Z-Wave firmware update via OTA.
Let the Z-Wave
TM
Controller into the firmware update mode, chose the hex file
to update. Wait for 10~15 minutes.
At that time,
please don't remove the battery
, otherwise it will
cause the firmware broken, and the device will no function.
Result will show in Z-Wave
TM
Controller log.
4
