3
Association
1. The PAN11 is an always listening
Z-Wave device, so associations
be added or removed by a controller
at any time.
Or If your controller requires to have
the PAN11 send a 'node information
frame' or NIF for associations,
pressing the On/Off button three
times within 2 seconds will cause
the PAN11 to send its NIF.
one press one flash LED
2. There are 3 groups for the switch
Including a node ID allocated by Z-Wave Controller means inclusion. Excluding a node
ID allocated by Z-Wave Controller means exclusion.
Failed or success in including/excluding the node ID can be viewed from the Z-Wave
Controller.
Sometimes people are not easy to execute exclusion or inclusion especially
when PAN07 already installed in a wall box. To solve this issue, PAN07 support
a special feature that can use S1 or S2 to execute exclusion, inclusion, Reset or
Association” at the first 3 minutes when first time connect to main power.
PAN09
does not support S1/S2 function.
LED Indication
To distinguish what mode the switch is in, view from the LED for identification.
State Type
LED Indication
Normal
Whatever we switch On and off of the PAN07/PAN09 by S1 S2 or
On/Off button or RF command, the LED will lights up 1 second and
then off.
No node ID
Under normal operation, when the Switch has not been allocated a
node ID, the LED flashes on and off alternately at 2-second
intervals. By pressing S1 S2 or On/Off button, it will stop flashing
temporarily.
Learning
When PAN07/PAN09 is in learning mode, LED flashes on and off
alternately and repeatedly at 0.5 second intervals.
Overload
When overload state occurs, the Switch is disabled of which LED
flashes on and off alternately at 0.2 second intervals. Overload
state can be cleared by disconnect and reconnect the Switch to the
main power
Choosing a Suitable Location
1. Do not locate the Switch facing direct sunlight, humid or dusty place.
2. The suitable ambient temperature for the Switch is 0°C~40°C.
3. Do not locate the Switch where exists combustible substances or any
source of heat, e.g. fires, radiators, boiler etc.
4.
After putting it into use, the body of Switch will become a little bit hot of
which phenomenon is normal.
Installation
1. Put in wall switch into a wall box and connect the AC power wire L,N to
PAN07/PAN09 connector L, N.
2. Connect the wall switch to the PAN07/PAN09 as Fig1/Fig2 .
