2. Pressing On/Off button three times
within 2 seconds will enter inclusion
mode.
Remove
(Exclusion)
1. Put your Z-Wave controller into
exclusion mode by following the
instructions provided by the
controller manufacturer.
2.
Pressing On/Off button three times
within 2 seconds will enter exclusion
mode.
Node ID has been excluded.
0.5s On, 0.5s Off (Enter
auto inclusion)
Reset
1.
Pressing On/Off button three times
within 2 seconds will enter inclusion
mode.
Use this procedure only in
the event that the primary
controller is lost or
otherwise inoperable.
2.
Within 1 second, press On/Off
button again for 5 seconds.
3.
IDs are excluded.
0.5s On, 0.5s Off (Enter
auto inclusion)
Association
1.
The PAN03 is an always listening
Z-Wave device, so associations
may
be added or removed by a controller
at any time.
Or If your controller requires to have
the PAN03 send a 'node information
frame' or NIF for associations, then
pressing the On/Off button three
times within 2 seconds will cause
the PAN03 to send its NIF.
2. There are only one group for the
switch
Adding a node ID allocated by Z-Wave Controller means inclusion. Removing a node
ID allocated by Z-Wave Controller means exclusion.
Failed or success in including/excluding the node ID can be viewed from the Z-Wave
Controller.
Sometimes people are not easy to execute exclusion or inclusion especially when
PAN03 already installed in a wall box. To solve this issue, PAN03 support a special
feature that can use S1 or S2 to execute “exclusion, inclusion, Reset or Association”
at the first 3 minutes when first time connect to main power. PAN10 does not support
S1/S2 function.
3
