COMMAND_CLASS_NOTIFICATION_V8
COMMAND_CLASS_FIRMWARE_UPDATE_MD_V4
COMMAND_CLASS_BATTERY
COMMAND_CLASS_SENSOR_MULTILEVEL_V11
COMMAND_CLASS_WAKE_UP_V2
Operation Mode
There are two modes “Test” and “Normal”. “Test Mode” is for the user
test the sensor function when installation. “Normal Mode” is for the
normal operation.
Operation Mode can be switched by pressing button or tamper key two
times. LED can indicate which mode it is. Lighting on one second
means entering test mode, flashing once means entering normal mode.
When the event triggered, normally the LED won't indicated, unless the
battery is in the low level, the LED will flash once. But in the “Test
Mode” the LED also will light ON one second.
When the event triggered, the device will emit the signal to turn ON the
lighting equipment, those nodes are in the group 2. And delay a while to
turn OFF the lighting equipment. The delay time is setting by the
configuration NO. 13.
The PIR motion re-detected interval, in the “Test Mode” fixed to 10
seconds. In the “Normal Mode”, it according to the setting of the
configuration NO. 12.
Choosing a Suitable Location
1. The recommended mounting height is 160cm
2. Don't let the device facing the window or the sunlight.
3. Don't let the device facing the source of heat. For instance, the
heater or the air-condition.
Battery Installation
When the device reports the low battery message, users should
replace the battery. The battery type is CR123A, 3.0V.
4
