4
Important - Do’s & Don’ts
• Confirm that the contents of the box are correct.
• Read this User Guide IN FULL before starting work.
• DO NOT cut corners with preparation or installation.
• Do use a qualified Electrician if any electrical work is carried out.
• DO NOT attempt any electrical wiring of the product unless you are a part P registered electrician.
• DO NOT use petrol, benzene, thinner, solvents or any similar chemicals to clean the panels.
• DO NOT let water drop directly onto the body or any electrical components.
• DO NOT brush any part of the panel with a wire brush or other hard object.
• A fused spur and circuit breaker must be installed if in a bathroom or other damp location.
• DO NOT remove any of the outer casing of the unit.
• DO NOT install in a sauna or steam room
• Installation location, must not be too close to curtains or other flammable materials.
• The product body and the panel must be firmly installed to avoid falling.
• DO NOT install near a smoke generator.
• DO NOT install in an industrial environment.
• DO NOT touch the panel surface when in use - let it cool down first.
Preparation
General Safety
The risk of accidents can be greatly reduced by careful planning before starting a project.
Always follow manufacturer’s operating and safety instructions before using tools and/or
equipment.
Before starting installation check structure is sound and check for hidden electrical wiring or
plumbing.
Before making any connections switch electricity off at the mains & fuse box.
We have not supplied wall fixings with this product. All walls differ in strength and thickness
and you will need to purchase suitable screws and wall plugs designed specifically for your
type of mounting surface. If in doubt we advise you to consult a professional builder for
guidance.
Installation in bathrooms, en-suites or similar rooms must be installed by a qualified
electrician in accordance with IEE wiring regulations and installations must conform to
BS7671 and Part P of the Building Regulations.
When the product is not in use, please turn off the power switch to save electricity and to
extend your product’s life. When switched off, the temperature display and backlight lamp
settings will be automatically stored to memory. These settings will be automatically restored
when the panel is switched on again.
