16
PART 4: OPERATION
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood
suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another
15 minutes approximately after terminating cooking.
Control panel with 6 buttons
To select the functions of the hood just touch the commands.
Light key ON/OFF
Intensive speed selection key
(suction power) - duration 5 minutes
:
the hood sets this power and
at the end of the 5 minutes returns to the previous setting.
High-speed selection key
(suction power).
Medium-speed selection key
(suction power) - when flashing it indicates the need to wash or
replace the carbon filter. This signal is normally deactivated. To activate the alarm, disable the
electronic by pressing the
0
button for 3 seconds.
Next, simultaneously press buttons
1
and
2
for 3 seconds; at first, only button
1
will flash, then both
buttons
1
and
2
will flash to indicate activation. Repeat the procedure to deactivate the alarm; at first
buttons
1
and
2
will flash and subsequently only button
1
to indicate deactivation.
Low-speed selection key
(suction power) – when flashing it indicates the need to wash the fats
filter.
Motor key OFF
(stand by) – excludes the electronics – reset wash/replace filters signals.
MOTOR OFF
Press briefly to switch the motor off.
RESET FILTERS SIGNALS
In functioning mode, after carrying out filter maintenance, press the key until hearing the sound
signal. The flashing LED
1
(grease filter) or
2
(carbon filter) stops flashing.
EXCLUDING THE ELECTRONICS
Press the key for 3 seconds. The hood command electronics will be excluded.
This function can be useful during the product cleaning operations.
Just repeat the operation to reinsert the electronics.
If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. by
pulling out the plug. Then plug it in again and try once more before contacting the Technical Assistance
Service.
