Philco PDA 1291 BIX, Руководство пользователя

Страница: 27 / 116

EN - 25
08/2012 Copyright © 2012, Fast ČR, a. s.
WARNING!
Short programs do not include the drying function. The above mentioned values were obtained on
the basis of laboratory tests according to relevant standards. These values may change depending
on conditions such as the type of dishes used, degree of dirtiness, type of dishwashing detergent,
water pressure, water hardness, etc.).
Turning on the appliance / starting a washing program
1. Pull out the lower and upper rack, load it with dishes and then slide back in.
We recommend that you fi rst load the lower rack and only then the upper rack (see “Load the dishwasher
racks”).
2. Fill the compartment with dishwashing detergent (see section “Dosage of the dishwashing detergent”).
3. Connect the power plug to the power socket. Power source is 220 - 240 V ~ 50 Hz, power socket specifi cation
12 A, 250 V ~. Check that the water inlet is fully open.
4. Press the ON / OFF button. The Start/Pause indicator light will turn on.
5. Use the program selector to select the desired program.
6. If necessary select an additional function.
7. Press the Start/Pause button to start the program. The indicator light of the selected program will turn
off when the program is started.
Monitoring the program
You can monitor the progress of the washing cycle by watching the indicator lights on the control panel turn
on and off .
NOTE:
Do not open the dishwasher until the ‘end of washing cycle’ indicator light turns on. During the drying
process the dishwasher will not make any sound for 40 – 50 minutes. This is a normal event.
Changing a program
A) Changing a program that is already running
1. Press the Start/Pause button.
2. After the washig cycle stops use the program button to select a new washing program.
3. The new washing program will replace the previous one. To start the new program press the Start/
Pause button.
B) Changing a program by resetting
1. Press the Start/Pause button.
2. Turn the program selector to the Reset position.
3. The program will be cancelled and the end of program indicator light will turn on.
4. Press the Start/Pause button once to drain water from the dishwasher.
WARNING!
It is dangerous to open the dishwasher door during a wash because you could be scalded by hot
water.