Philco PD 1251 BiT, Руководство пользователя

Страница: 26 / 116

EN - 24
10/2012 Copyright © 2012, Fast ČR, a. s.
WARNING!
Short programs do not include the drying function. The above mentioned values were obtained on
the basis of laboratory tests according to relevant standards. These values may change depending
on conditions such as the type of dishes used, degree of dirtiness, type of dishwashing detergent,
water pressure, water hardness, etc.).
NOTE:
The above provided values are only for your orientation. They have been determined on the basis of
laboratory tests in accordance with respective standards. The values may diff er depending on the
conditions under which the appliance is used and other factors such as pressure, water pressure, water
temperature, ambient temperature, etc.
Turning on the appliance / starting a washing program
1. Pull out the lower and upper rack, load it with dishes and then slide back in.
We recommend that you fi rst load the lower rack and only then the upper rack (see “Load the dishwasher
racks”).
2. Fill the compartment with dishwashing detergent (see section “Dosage of the dishwashing detergent”).
3. Connect the power plug to the power socket. Power source is 220 - 240 V ~ 50 Hz, power socket specifi cation
12 A, 250 V ~. Check that the water inlet is fully open.
4. Press the ON / OFF button.
5. Use the program selection button to select the desired program.
6. If necessary select an additional function.
7. Close the door to automatically start the program. The indicator light of the selected program will turn off
when the program is started.
Monitoring the program
You can monitor the progress of the washing cycle by watching the indicator lights on the control panel turn
on and off .
NOTE:
Do not open the dishwasher until the ‘end of washing cycle’ indicator light turns on. During the drying
process the dishwasher will not make any sound for 40 – 50 minutes. This is a normal event.
Changing a program
A) Changing a program that is already running
1. Carefully open the door. Wait until the spraying arms stop. Allow excess steam to escape.
2. Select a new program.
3. Close the door and the new program will start.
B) Cancelling a program
1. Carefully open the door. Wait until the spraying arms stop. Allow excess steam to escape.
2. Press and hold the program selection button for approximately 3 seconds. The end of program
indicator light will start fl ashing and the program indicator light will turn off .
3. Close the door and the dishwasher will automatically drain the water, approximately 30 seconds after
the door is closed. After this a sound will be made 5 times.
WARNING!
It is dangerous to open the dishwasher door during a wash because you could be scalded by hot water.