Philco PD 114 WE, Руководство пользователя, Страница: 26 / 192

Copyright © 2019, Fast ČR, a. s. Revision 02/2021
EN - 24
NOTE:
If operate from step 1 to step 2, the filter system will be removed; while operate from step 2 to step 1, the
filter system will be installed
3
.
Filter assembly
For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food
particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is a good idea
to remove the larger food particles trapped in the filter after each wash cycle by rinsing the semicircular filter
and cup under running water. To remove the filter assembly, pull on the cup handle in the upward direction.
The entire filter assembly should be cleaned once a week. To clean the coarse filter and the micro filter, use
a cleaning brush. Then, reassemble the filter parts as shown in the figures above and reinsert the entire
assembly in the dishwasher, positioning in its seat and pressing downward. The dishwasher must never be
used without he filters. Improper replacement of the filter may reduce the performance level of the appliance
and damage dishes and utensils.
WARNING!
Never run the dishwasher without the filters in place. When cleaning the filters, don’t knock
on them. Otherwise, the filters could be contorted and the performance of dishwasher could
be debased.
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm jets and
bearings.
To remove the spray arms, screw off the nut clockwise to take out the washer on top of the spray arm and
remove the arm. Wash the arms in soapy and warm water and use a soft brush to clean the jets. Replace them
after rinsing thoroughly.
Caring for the Dishwasher
To clean the control panel, use a lightly dampened cloth then dry thoroughly.
To clean the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.