Philco PD 114 WE, Руководство пользователя, Страница: 15 / 192

Copyright © 2019, Fast ČR, a. s. Revision 02/2021
EN - 13
Please observe the manufacturer’s dosing and storage recommendations as stated on the detergent
packaging.
Close the lid and press until it locks in place.
If the dishes are heavily soiled, place an additional detergent dose in the pre-wash detergent chamber. This
detergent will take effect during the pre-wash phase.
NOTE:
You find information about the amount of detergent for the single programme on the last page.
Please be aware that according to the level soiling and the specific hardness of water, differences are
possible. Please observe the manufacturer’s recommendations on the detergent packaging.
Detergents
There are 3 sorts of detergents
1. With phosphate and with chlorine
2. With phosphate and without chlorine
3. Without phosphate and without chloride
Normally new pulverized detergent is without phosphate. The water softener function of phosphate is not
given. In this case we recommend to fill salt in the salt container even when the hardness of water is only 6
dH. If detergents without phosphate were used in case of hard water often white spots appear at dishes and
glasses. In this case please add more detergent to reach better results.
Detergents without chlorine do only bleach a little. Strong and coloured spots will not removed completely.
In this case please choose a programme with higher temperature.
Use of “3 in 1” Detergent Tablets
General Advice
1. Before using these products you should fi rst check that the water hard-ness in your supply is compatible
with the use of these products as per the detergent manufacturers instructions (on the product
packaging).
2. These products should be strictly used according to the detergent manufacturers instructions.
3. If you encounter problems when using “3 in 1” products for the first time then please contact the
detergent manufacturers care line (the telephone number is given on the product packaging).
These products are detergents with integrated and combined detergent/rinse aid and salt functions.
Before using these products you should first check that the water hardness in your supply is compatible with
the use of these products as per the detergent manufacturers (on the product packaging).
Special Advice
When using combination products, the rinse-aid and salt lights are no longer useful. It may be helpful to
select the lowest possible setting for water hardness.
To select “3in1” function:
1. Press the power switch and select the 3in1 washing cycle by pressing the option button until the “3in1”
indicator blinks.
2. The 3in1 washing cycle will be available after pressing the “start/pause” button, and the “3in1” indicator
lights.