EN - 17
12/2013
Copyright © 2013, Fast ČR, a. s.
CAUTION!
Do not use sharp objects for the removal of frozen food or ice, the wall of the freezer could be scratched.
When defrosting the freezer never use electric appliances such as hair fans, hot air fans, steam cleaners, de-
icing sprays or open fl ames (e.g. candles). The plastic interior could melt and the resulting foam gas could be
ignited from a spark or an open fl ame. Never use a steam cleaner to melt a layer of ice in the appliance (high
risk of injury by electrical shock).
Remove the frozen food and wrap into several newspaper layers.
Place the frozen food in a cold place until it is possible to use the freezer again.
Leave the freezer door open.
Ice deposit layers form in the freezer during the normal course of operation. After exceeding a certain thick-
ness, they function as insulation and interrupt heat transfer.
Do not scratch the ice deposit layer because you could damage the evaporation surface.
Perform the defrosting process as fast as possible to prevent the removed food from defrosting.
Constantly remove water using a sponge.
You can speed up the defrosting process by placing a bowl with hot water (not boiling) into the freezer. In
this case close the freezer door.
As soon as the freezer has been fully defrosted, empty the water accumulated in the bowl into a kitchen sink.
Wipe the freezer area until dry and return the food.
Connect the appliance to the power socket.
Cleaning gasket seals
Keep the door gasket seals clean.
Sticky foods and beverages may cause the gasket seal to stick to the inner edge and result in damage when
the door is opened. Wash the gasket seal with a soft wiping cloth dipped in warm water with a small amount
of kitchen detergent. Rinse and thoroughly wipe dry.
CAUTION!
Only turn on the appliance once the gasket seal is thoroughly dry.
Replacing the light
Light tube
(inside)
Temperature
control dial
Light tube cover
Warning:
The light must be replaced by a service technician or qualifi ed person! If the LED light is damaged, please
contact an authorised service centre. To replace the LED light, proceed as follows:
1. Disconnect the appliance from the power socket.
2. Remove the light cover using a screwdriver.
3. Replace the light tube and put the cover back in its place.
