Soak wash
1. Switch on the power.
2. Open the tap and lay down the drain hose.
3. Put in clothes and detergent.
4. Select proper water level according to the weight of clothes.
5. Select the "Function" and "Program".
6. Press the "Function" button, the lights of "Soak" "Wash""Rinse""Spin" will turn on.
7. Press "Start/Pause" button and close the lid.
Confirmation of soak:
After pressing on the "Start/Pause" button, the icon "Soak" will flitter.
Wash of blanket
The weight of the blanket should be less than 3kg, and please select the heavy program to wash and it had better use
particular mesh bag for the heavy washing and the method is as follows:
1. After the detergent is dissolved with proper amount of warm water (below 50
), pour it into the tub of the washing
machine.
2. Fold up the blanket and put it into the washing tub.
3. Switch on the power and press the "Program" button to select the "Heavy wash" program and "Level 6" or "Level 5"
water level.
4. Press the "Start/Pause" button, and close the lid.
5. After ending of washing, dry in the ventilated place with sunshine.
6. Only the blanket with marks
"Hand wash" can be washed.
Use of fabric softener
Fill softener into the injection mouth for fabric softener (at the tub mouth).
Wash of bulk clothes
Please put the bulk clothes into mesh bag in time of washing, and then add washing powder and select the full process
program to wash them.
Pre-wash of the dirty clothes
As for seriously stained dirty clothes with mud, one of the "R
inse-spin" program can be selected to perform pre-washing,
and then add washing powder and select the fully automatic program to wash them.
11
12
WAY OF USE
Placement of the washing machine
The washing machine should be placed inside the room with a flat floor, which is convenient for water
supply and drain, has low moisture and no direct sunshine, and does not freeze in winter. All foam packing
(including the fixing frame on the base foam) should be taken off, otherwise the washing machine will not
work.
Please adjust the washing machine according to the instructions below to make the washing machine run
steadily.
1.
Loose the fixing pole on the adjusting foot, screw in or screw out the adjusting foot to make the four
braces placed even on the floor. (the adjusting foot is on the left front bottom of the cabinet).
2.
When the floor is slanting or uneven, it is not easy to make even only by the adjusting foot. Then the
rubber band can be added to the unflat place.
3.
Open the cover lid and watch gradienter, when the air bladder move to the red circle mark in the
gradienter, or see the hole of the top frame and the washing tub are found to be basically in alignment,
that is to show that the washing machine is placed flat, just like followed figure.
4.
After the adjustment the fixing pole should be screwed back and tight.
Notices:
o
If the washing machine is not placed flat (the inclination angle is over 2 ), it may cause great vibration or
automatic check and rectification or other abnormal circumstances will often take place in the course of
spinning.
Base foam
Fixing frame
Screw in
Screw out
Loose
Adjustable foot
Fixing pole
Tight
INSTALLATION
Air bladder
The mark of gradienter
