WAS-105R IEEE802.11n Wireless Hotspot Gateway
Quick Installation Guide
7
2. Hardware Installation
Please follow the steps mentioned below to install the hardware of WAS-105R
1. Place the WAS-105R at a best location.
The best location for WAS-105R is usually at the center of your wireless network.
2. Connect WAS-105R to your outbound network device.
Connect one end of the Ethernet cable to the WAN1/WAN2 port of WAS-105R on the front panel. On your
environment, connect the other end of the cable to the external Internet. The WAN1/WAN2 LED indicator
should be ON to indicate a proper connection.
3. Connect WAS-105R to your network device.
Connect one end of the Ethernet cable to LAN port of WAS-105R on the front panel. Connect the other end of
cable to a PC for configuring the system. The LAN LED indicator should be ON to indicate a proper
connection.
4. There are two ways to supply power over to WAS-105R
Î
Connect the DC power adapter to the WAS-105R power socket on the front panel.
Please only use the power adapter supplied with the WAS-105R package. Using a
different power adapter may damage this system
Î
WAS-105R is capable of transmitting DC current via its LAN(PoE) port. Connect an IEEE 802.3af-
compliant PSE device, e.g. A PoE Switch, to the LAN(PoE) port of WAS-105R with the Ethernet
cable.
Now, the hardware installation is completed.
To double verify the wired connection between WAS-105R and your switch/router/hub,
please check the LED status indication of these network devices.
