4
3
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
POWER
LOCK
MENU
OUT
A
1
B
2
C
3
D
4
IN
E
5
F
6
G
7
H
8
8X8 HDMI MATRIX over CAT5e/6 CMSI-8H8CV
2
3
4
5
6
1
1
LCM:
Displays the setting information of each input and output
setting.
2
POWER:
Press this button to power the device on/off. The LED will
illuminate green when the power is on, red when it is in 'Standby'
mode.
3
LOCK:
Press this button to lock all the buttons on the panel; press
again to unlock. The LED will illuminate green when locked.
4
IR:
IR Receiver window (accepts the remote control signal of this
device only) with IR frequency of 38kHz.
5
MENU:
Press this button to access the LCM menu system, from
here EDID settings can be managed and IP system settings are
displayed.
6
1~8/A~H and OUT/IN:
Press the OUT or IN button to select the
output or input mode and then press the required number button
to make the selection accordingly.
For example, if outputs A~D need to be set to input 1 and outputs
E~H need to be set to input 2, then the following sequence of
button presses need to be performed:
Press: OUT
A
B
C
D
IN
1
MENU,
and then press: OUT
E
F
G
H
IN
2
MENU.
Note:
If the MENU button is not pressed the selection will not be
changed.
5
11
PoE 24V:
Plug the 24 V PoE power supply into the unit and connect
the adaptor to an AC outlet. This unit will mainly power PoE (Power
over Ethernet) capaable receiver units.
Warning: Please do not connect the CAT5e/6/7 cable into the
receiver's LAN port.
6.3 Side Panel
1
1
Fan Ventilator:
These are air ventilation areas, DO NOT block these
areas or cover it with any object. Please allow adequate space
around the unit for air circulation.
6.4 Remote Control
1
POWER:
Press this button to
switch on the device or set it to
standby mode.
2
IN
: Input ports selection 1~8.
3
OUT
: Output ports selection A~H.
Note:
This remote control can
also be used from the reciever
side to control the matrix's
setting.
1
2
3
1
A
B
2
C
3
4
D
CR-121
IN
OUT
