background image

5

Usage Cautions

Care of Equipment

If the equipment is covered with dust or dirt, clean it with a soft cloth.
If the equipment is very dirty, put detergent which is thinned very well with water on a soft 
cloth. Wring the cloth and wipe off the dust and dirt. Then clean with a dry soft cloth.
Never use chemical agents such as thinner, naphtha or alcohol when cleaning it. 
If any of them is attached to the equipment, the silk printing can be flaked or the surface can 
lose metal luster.

Cautions on installation

*

*

*

Wall

*

•  More than 0.1 m is recommended.

•  Do not place any other equipment on this unit.

*

 For proper heat dispersal, do not install this unit in a confined space,

   such as a bookcase or similar enclosure.

CAUTION:

To  completely  disconnect  this  product  from  the  mains, disconnect  the  plug from the wall socket outlet.
The mains plug is used to completely interrupt the power supply to the unit and must be within easy access by the user.

A NOTE ABOUT RECYCLING:

This product’s packaging materials are recyclable and can be reused. Please dispose of

any materials in accordance with the local recycling regulations.

When discarding the unit, comply with local rules or regulations.

This product and the supplied accessories constitute the applicable product

according to the WEEE directive.

NOTE ON USE

WARNINGS

Avoid high temperatures.

Allow for sufficient heat dispersion 

when installed in a rack.

Handle the power cord carefully.

Hold the plug when unplugging 

the cord.

Keep the unit free from moisture, 

water, and dust.

Unplug the power cord when not 

using the unit for long periods 

of time.

Do not obstruct the ventilation 

holes.

Do not let foreign objects into 

the unit.

Do not let insecticides, benzene, 

and thinner come in contact with 

the unit.

Never disassemble or modify the 

unit in any way.

Ventilation should not be impeded 

by covering the ventilation 

openings with items, such as 

newspapers, tablecloths or 

curtains.
Naked flame sources such as 

lighted candles should not be 

placed on the unit.

Observe and follow local 

regulations regarding battery 

disposal.

Do not expose the unit to dripping 

or splashing fluids.

Do not place objects filled with 

liquids, such as vases, on the unit.

Do not handle the mains cord 

with wet hands.
The equipment shall be installed 

near the power supply so that the 

power supply is easily accessible.

Do not keep the battery in a 

place exposed to direct sunlight 

or in places with extremely high 

temperatures, such as near a 

heater.

Содержание EA-2000















Отзывы: