6
of the display – making sure that this mark is level with the mark on the
left side. This will create two marks that are the correct mounting distance
apart and 2” below the bottom of your display
(Figure 3)
. You have now
identified the location for the two wall brackets for the TEATRO
®
speaker.
Using a 1/16” drill bit, drill a pilot hole at each of your two marks above.
Place one of the wall brackets on the wall and align the pilot hole with the
bottom slot on the bracket and drill a second pilot hole in the center of the
upper slot on the bracket (See Figure 4). This hole will be 7/8” above the
first pilot hole. Repeat this process for the bracket on the other side. These
pilot holes will let you know if your mounting bracket location is over a wall
stud or not. If it is over a stud then that bracket can be installed with a
suitable screw (for mounting on sheetrock walls, we recommend at least a
#10 x 1.5” pan head screw and a flat washer between the screw and the
bracket). If the location for the bracket is not over a wall stud, then suitable
drywall anchors that can support 15 lbs. each must be used.
Following the guidelines above, mount the two brackets to the wall. Once
they are installed check that the center distance between the vertical
mounting slots on the two brackets is exactly as specified in the reference
table. Adjust the brackets with the horizontal slots until on they are the
specified distance apart.
STEP 2-C – TABLE TOP MOUNTING
The TCE1.5 speaker is supplied with a Plexiglas table top stand for vertical
placement; please refer to the instructions included with the stand for
assembly. This stand is optional for the TFS1.0 speaker.
2”
2”
[Figure 3]
FLAT PANEL DISPLAY
[Figure 4]
FLAT PANEL DISPLAY
CENTER
[Figure 5]
[Figure 6]
TFS1.0 TABLE TOP FOOT ASSEMBLY
Place your TFS1.0 speaker face down on a soft clean surface. Orient the
speaker so the input terminal is on the right hand side. Attach the Table Top
Mounting Feet to the bottom of the bracket using the two supplied Phillips
Table Top Mounting Feet Screws. Make sure that you orient the feet so
that the longer side extends under the TFS1.0
(Figure 5)
. Repeat this for
the other Mounting Bracket and Table Top Mounting Foot. Once you have
the Table Top Mounting Feet securely fastened to the Mounting Brackets,
it is now time to mount them to the TFS1.0. Align the center of the vertical
slot on the Mounting Bracket with the center of threaded brass inserts on
the rear of the speaker and fasten using the supplied Table Top Mounting
Screws, one for each bracket.
(Figure 5)
.
STEP 3 – SPEAKER HOOKUP
There are Euroblock connector terminals on the rear of the speaker
cabinets. The terminals are marked for Front Input or Center Input on the
TCE1.5 speaker or just Input on the TFS1.0 and should be connected to
the respective speaker channel outputs on your receiver
(Figure 8)
. Be
careful to observe proper polarity; + (red) on your receiver to + on the
speaker Euroblock connector. Strip about .25” of insulation from the wires
and separate the wires as necessary. Using a small flat blade screwdriver,
connect the signal wires to the 2-pin Euro-block connectors, (+) indicates
positive and (-) indicates negative. Please reference your receiver owner’s
manual for proper speaker connection. Make sure the connections are
tight. Tuck the speaker wires behind the speaker cabinets, using tie wraps
if necessary.
(Figure 6)
.
Содержание Teatro
Страница 1: ...OWNER S MANUAL INSTALL GUIDE...
