Phase Technology TEATRO TSB3.0, Руководство пользователя / Инструкция по установке

Страница: 6 / 9

6
[FIGURE 4]
on the Mounting Bracket with the center of mounting holes on
the rear of the speaker and fasten using the supplied Table Top
Mounting Screws for each bracket.
Note:
When mounting the table top brackets, fasten the brackets
to the far end mounting holes on each side of the speaker cabinet.
STEP 3
There are three Euroblock connector terminals on the rear of the
speaker cabinet. The terminals are marked for Right Input, Center
Input and Left Input and should be connected to the respective
speaker channel outputs on your receiver. Connect the speaker
wires to the correct terminals observing the polarity indicated on
the Euroblock connector. Strip about .25” of insulation from the
wires and separate the wires as necessary. Connect the signal
wires to the 2-pin Euroblock connectors ((+) indicates positive and
(-) indicates negative)
(Figure 5) . Make sure the connections are
tight. Tuck the speaker wires behind the Soundbar cabinet, using
tie wraps if necessary to secure wires.
OFF ON
EVT
[FIGURE 6]
With emblem removed
[FIGURE 5]
STEP 4
Since the TSB3.0 speaker performs as the front three speakers
in a home theater system they are to be used and set up as you
would any normal 5.1 to 7.2 surround sound system for balance
and level adjustments. For the best performance, the amplifier
should be set to the small speaker mode for the left/center/right
front speakers. The subwoofer setting should be set between
80 - 100 Hz. We recommend the use of our Phase Technology
®
subwoofers and surround speakers to complement your TSB3.0.
STEP 5
The EVT
™
switch (Figure 6) , located on the front of the speaker
under the Phase Technology emblem on the grille, activates Phase
Technology’s Enhanced Voice Technology feature. This feature is
designed to improve the clarity of the voice or dialogue from the
center channel speaker in the system. Flipping the switch to the
on position (right) engages the circuit and off position (left) turns
it off. The emblem can easily be removed and
replaced. Use the
tip of a pencil or a small screw driver to engage or turn off the EVT
function.