Phase Technology TEATRO TSB3.0, Руководство пользователя / Инструкция по установке

Страница: 4 / 9

4
[MOUNTING INSTRUCTIONS]
When selecting the speaker mounting location, it is prudent to
take a few extra minutes to carefully inspect and measure the wall
where you intend to mount the TSB3.0 speaker and your flat panel
display. An inspection of the room, or rooms, that back up to the
wall you have selected for mounting the TSB3.0 can often alert
you to potential obstacles. An electronic stud-finder is a useful tool
to assist you in selecting the speaker placement, but be cautious
as they often give false readings. For example, if the wall you
want to mount to happens to be the common wall for a bathroom
or kitchen, there is a good chance you will encounter water or
sewer pipes in the wall that will not be detected by a stud-finder.
It is recommended, that wherever possible, you try to fasten these
mounting brackets to a vertical stud with the appropriate wood
screws. If it is not possible to mount the brackets over the studs
then it is recommended that the appropriate hollow wall anchors
or toggle bolts be used to mount the TSB3.0.
Note: In order for the Spatial Field Expanders to operate correctly,
the sides of the soundbar must not be obstructed.
STEP 1
Determine that the desired mounting location is safe and clear of
any physical obstructions that might hinder the proper installation
of the speakers. If the flat panel monitor is already installed on the
wall you can use it as a guide for the installation of the speaker.
For the best appearance, it is recommended that the speaker
be installed symmetrically beneath the monitor. The Soundbar’s
response characteristics will be best if you mount it within a few
inches of the flat panel display.
Special consideration must be taken to run three (3) sets of
speaker leads to the TSB3.0 speakers. One pair each will be
16”
2.5”
Flat panel display
[FIGURE 1]
connected to the left and right channel on your amplifier and the
other pair will be used for the center channel. Be certain that you
can get the speaker wire to the locations where you plan to mount
the speaker systems.
Please note that the TSB3.0 speakers are designed to mount
very close to the wall and the brackets only allow about .5” of
clearance so be certain to make allowances for this with your
speaker connectors and wire clearances.
We suggest that you use a minimum of AWG 16 wire. Pre-run your
speaker wire to the determined locations and be certain to leave
about two feet of extra wire for the final speaker installation. If the
flat panel monitor is not yet mounted to the wall, mount the display
first before mounting the speakers.