Install instructions for TEATRO Soundbar models, Page 3
6400 Youngerman Circle / Jacksonville, FL 32244 / (888)PHASE TK / www.phasetech.com
Step 5
The TEATRO sound bar speaker is now ready to be mounted to the
brackets that were screwed to the wall in step 2. The brackets are
made to interlock with each other. Raise the speaker so the brackets
on the rear of the cabinet are aligned with the wall brackets and
engage the “J” bends in the two sets of brackets together. If the
speaker is being installed very close to the bottom of the flat panel
display the speaker brackets can be slid into each other from the side.
After the brackets are interlocked, it is a simple matter to center the
speaker by sliding it side to side. The speaker can also be leveled by
turning in the appropriate height adjusting screw to raise and lower
the ends of the speaker. This is done with a #2 Phillips screwdriver
from the bottom side of the bracket. Once the speaker position is
trimmed up it should be locked in place using the 4 locking screws in
the speaker bracket (Fig. 3). Be careful not to over-tighten the screws.
Adjust the rubber stand-off bumpers by turning them either in or out
to adjust the tilt of the speaker until the front is vertical. Lock the
adjusting screws in place by tightening the locking nuts against the
rear of the cabinet. Make certain the nylon washer is between the nut
and the cabinet to protect the cabinet finish.
Step 6
Since the TEATRO sound bar speakers perform as the front three
speakers in a home theater system they are to be used and set up as
you would any normal 5.1 to 7.2 surround sound system for balance
and level adjustments. For the best performance, the amplifier should
be set to the small speaker mode for the left/center/right front speak-
ers. The subwoofer setting should be set to 80 Hz. We recommend the
use of our Phase Technology subwoofers and surround speakers to
complement your TEATRO Soundbar.
Step 7
The EVT™ switch (Fig. 4), located on the front of the speaker under the
grille, activates Phase Technology’s
Enhanced Voice Technology
feature. This feature is designed to improve the clarity of the voice or
dialogue from the center channel speakers in the system. Flipping the
switch to the up position engages the circuit and down turns it off.
Figure 4
Mounting To Flat Panel Mounting Brackets
There are additional mounting inserts on the rear of the speaker
cabinet to facilitate flat panel mounts (see note on Figure 1). There are
six threaded inserts provided that coincide with the requirements of
most manufacturers’ mounts. Please check with your Phase Technol-
ogy dealer for appropriate mounts and compatibility.
SPEAKER MOUNTING BRACKET
LEVELING ADJUSTMENT SCREW
IN WALL BRACKET
LOCKING SCREWS IN
SPEAKER BRACKET
WALL MOUNTING BRACKET
Figure 3
TEATRO SOUND BAR SPEAKER SPECIFICATIONS
MODEL
T-V3.0
T-PC3.0
TWEETER
1” SOFT DOME x 3
1” SOFT DOME x 3
MIDRANGE
-----
1.5” SOFT DOME x 3
WOOFER
5.25” VDT x 3
5.25” RPF x 3
FREQUENCY
55Hz-22kHz
52hz-22kHz
SENSITIVITY
91 dB
89 dB
IMPEDANCE
4 OHMS
4 OHMS
MAXIMUM POWER
120 WATTS
150 WATTS
DIMENSIONS
40” (W) x 7” (H) x 4 ” (D) (5 ” with bracket)
FINISH
SATIN BLACK
GLOSS BLACK
WEIGHT
25 LBS
30 LBS
