background image

1.

2.

1. Nail or screw bracket to 
joists.

2. Finish installing ceiling.

8. Remove paint mask 
unless painting is required. 
In that case, follow steps 
9-12 when painting is 
complete.

 

10. Attach grille safety clip 
by placing the large end of 
the clip over snap-fit post (1), 
then sliding clip until small 
end snaps into place around 
post (2).

 

 

3. Use RotoZip or other tool 
to cut hole.

6. If required, attach 
seismic restraint system to 
the sheet-metal tab on the 
rear panel of the speaker, 
then to reinforced structure 
(safety cable not included).

11. Align tabs on snap-fit 
grille with slots in baffle, 
gently press grille into place.

4. Unpack speaker. Leave 
paint mask in place until 
after speaker is installed or 
painting is complete.

12. Done!

 

T E C H N O L O G Y

Installation Instructions: Installing the CI-1.5 
Using Optional Pre-Construction Bracket

R

9. Adjust tap switch to 
proper setting.  Switch is 
preset to the 8-ohm mode.

5. Connect euroblock to 
speaker wires, and connect 
to speakers.

7. Insert speaker into 
mounting hole. Tighten both 
screws on the baffle face to 
actuate the mounting wings. 

DO NOT OVERTIGHTEN.

Отзывы: