Phase Technologies 2XD Series, Руководство по эксплуатации и установке

Страница: 19 / 84

13 | P a g e
3.2 Source Branch Circuit Protection
Branch circuit protection must be installed in the circuit sourcing the drive. See
Table 3 for
recommended circuit breaker/fuse sizing, which is based on 125% of the rated input current. Fuses may
be used for circuit protection; consult local electrical code for proper sizing. Installation of a disconnect
means within sight of the drive is recommended.
Table 3
– Fuse/Breaker Recommendations
Model Input Current Fuse/Breaker
SD002 20 A 25 A
SD003 30 A 40 A
SD005 42 A 55 A
SD007 58 A 75 A
SD010 69 A 90 A
SD015 92 A 115 A
SD405 30 A 40 A
SD407 37 A 50 A
SD410 42 A 55 A
SD415 56 A 70 A
2XD205 31 A 40 A
2XD207 52 A 65 A
2XD210 64 A 80 A
3.3 Installing Power Cables
CAUTION: Installations must comply with all NEC and local electrical code requirements.
Connection to input and output power is made on the power terminal block. See
Table 4 for connection
descriptions and Figure 14 for terminal block locations.
Important Note About Output Filters:
Models that include a sinewave filter have a different power terminal connection configuration. Refer to
Figure 15 for connecting models with output filters.
Table 4
– Power Terminal Descriptions
Terminal Name Description
L1, L2 Input power terminals for single-phase input
U, V, W Output power terminals for three-phase output
BUS - *Important* DO NOT connect power
GND Earth safety ground
Table 5
– Power Terminal Descriptions – SD002, SD003 only