phase II+ 220-006, Инструкция по эксплуатации и каталог запасных частей

Страница: 8 / 13

Operating Instructions & Parts Manual
Horizontal Rotary Tables
Dividing Plates
Pg.
8
Troubleshooting Chart
Symptom Possible Cause(s) Corrective Action
Handwheel rotates:
Table does not rotate
1.Key(Ref.No.32) is missing 1. Insert Key
2. Worm Shaft disengaged 2. Engage worm shaft
(see operation)
Handwheel will not rotate 1. Hold‐down clamps are
too tight
2. Lock nut too tight
(see maintenance)
3. Table need lubrication
1. Loosen hold‐down clamps
2. Adjust lock nut properly
3. Lubricate properly
(see Maintenance)
Worm Shaft will not engage
Table Eccentric sleeve cannot rotate
properly Properly adjust threaded pin and
Set screw(see maintenance)
Worm Gear / Eccentric Sleeve Adjustment
First Loosen Handle A for the eccentric sleeve lock and proceed to unscrew Bolt B .
Screw clockwise the Limiting Bolt A to adjust the mesh of the worm gear to the table top gear.
At this time, rotate the handle wheel clockwise and counterclockwise to ensure the mesh of the
worm gear is within 6° and then tighten the
Locking Bolt B and then clamp the Handle A to
lock the eccentric sleeve.
Screw counterclockwise the
Limiting Bolt A to reduce the mesh and proceed to rotate the
handwheel to ensure the mesh of the worm gear is within 6° and then tighten Locking Bolt B.
Rotate the Indicator counterclockwise until the Bolt C is touching the Locating Pin. This
procedure has just disengaged the worm gear. Rotate the indicator clockwise until Bolt D is
touching Bolt A. Now the worm gear is engaged.