GLACIER C350ap
MANUAL V1.0
STEP 4. APPLYING THERMAL COMPOUND
FINAL STEP. POWER ON
Please check the following:
- Make sure the block is seated properly on the CPU.
- Always perform a leak test before turning on the system.
- Use paper towels under fittings and joints to avoid damage.
- Make sure all hardware has been tested before starting your
water loop.
Make sure the CPU is clean and clear of any residual traces of thermal paste.
Apply a dot (4-5mm size) of Phanteks thermal compound on the center
of the CPU surface.
Let the pump run for multiple hours. Tilting the system
can help to release air bubbles.
STEP 5. INSTALLING THE C350ap Block
Remove the protective film on the copper base first.
Place the C350ap block on the CPU and tighten the thumb-screws by hand.
Thanks to the C350ap’s symmetrical design. Both ports can be used as
an inlet or outlet for the water loop.
By securing the screws in a diagonal sequence, the mounting pressure
will be distributed evenly. This optimizes the cooling performance.
Do not use force to overturn the thumb-screws. Please stop when
the screws are at a natural stop.
