aterMark
W
aterMark
W
TM
pH MIRACLE
THE
®
8
(Some homes have very old and even rusty cold water shut off valves; in this case it may be nec
-
essary to install a new cold water shut off valve to assure a leak proof installation; this should
be done by a licensed plumber if you are not able. The pH Miracle is not liable for poor quality
installs using old unstable parts.)
4. Now take your pliers and loosen the nut on top of the cold shut off valve, this is where the hose
from the faucet above is attached to the valve, unscrew with a counter clockwise motion. Unscrew
and move the hose to the side.
5. Locate the white plastic Quick Connect Water Supply Diverter, there should be two sizes one is
for ½ inch thread and the other is for ⅜ inch thread. Locate the piece that fits onto your cold water
shut off valve, the piece should screw on easily, do not force it, hand tighten only. It isn’t necessary
to use tools to install this piece. If the part is leaking after install then try to snug a little tighter by
hand until leak stops.
6. Now re-connect the main faucet hose to the new plastic water supply fitting, use pliers to tighten
just more than hand tight. Do not over tighten.
7. Take one end of the plastic tubing and insert it into the plastic faucet supply piece you just in-
stalled, be sure to push tubing all the way in. You may choose to cut the plastic tube to the appro-
priate length or gather the extra tube under the sink. If you cut it, be sure it’s long enough to reach
the WaterMark where it will sit under the sink. Do nothing with the other end of the tube for now.
8. Locate Accessory Faucet and install at hole on sink or counter top. Use the instructions printed
on the Accessory Faucet box to install the faucet. The Accessory Faucet comes as four parts: 1) Main
spout, 2) Body, 3) Base collar, and 4) Accessory Kit which includes washers and nuts. (See labeled
image of contents on page 6.)
Once the Accessory Faucet is installed, then you will need to connect the plastic tubing to the bot-
tom of the faucet shaft. Use directions on back of faucet box to connect tubing.
At this point you should have 2 tubes with 2 loose ends, one coming from the cold water shut off
valve, the other coming from the new accessory faucet shaft under the sink.
9. Position the WaterMark under the sink where it will stay, and connect the end of the plastic tube
coming from the cold water shut off valve into the ‘Inlet” connector on the back of the WaterMark;
be sure to push in the tube all the way.
10. Connect the tube from the Accessory Faucet shaft to the “Outlet” connector on back of Wa-
