PG Drives Technology VR2 series, Руководство по эксплуатации и установке

Страница: 118 / 152

VR2 C
ONTROL
S
YSTEM
SK77898/2
PG
DRIVES TECHNOLOGY
106
1.2.2 Fitting a Joystick
- Ensure Gaiter/Rubber-boot is positioned with the flange firmly against the
underside of the Top Section.
- Ensure the joystick is in the correct orientation. The notch on the joystick plate
should lineup with the Key in the Top Section.
• Slide joystick up through the Top Section.
• Check the seal of the Gaiter/Rubber-boot and secure using the 2 retaining
screws.Tightening to 0.8Nm, 7 inch/lbs
• Connect the Joystick Cable to the Power Module.
• Power up the VR2 with the Joystick Ribbon Cable disconnected. The VR2
should flash the left most speed Led.
• The VR2 will now enter the Calibration sequence .
• Connect the Ribbon Cable and make sure the joystick is centered.
• Press the horn key until the VR2 bleeps.
• The 2 left most speed display LEDs will flash.
• Push and hold the joystick fully forward and press the horn key until the VR2
bleeps.
• The 3 left most speed display LEDs will flash.
• Push and hold the joystick fully to the left and press the horn key until the VR2
bleeps.
• The 4 left most speed display LEDs will flash.
• Push and hold the joystick fully to the right and press the horn key until the VR2
bleeps.
• All 5 speed display LEDs will flash.
• Pull the Joystick fully back and press the horn key until the VR2 bleeps.
• The speed display will go out and the TruCharge display will flash all 10 LEDs.
• Turn the VR2 off.
• Isolate the Joystick Module by disconnecting the Joystick Cable from the
Power Module.
• Reassemble the joystick module, ensuring the rubber gasket is correctly
positioned, and replace the 5 retaining screws. Tightening to 0.8Nm, 7 inch/
lbs
Incorrect fitting of the Gasket could seriously affect the
Joystick Module’s resistance to moisture ingress.
• Turn the controller on again.