5. DMX Output:
Male 3 pin used to connect to next DMX fixture in the chain.
6. Power Switch:
To turn the smoke machine on and off.
7. Fuse Holder:
If this blows once, replace if the correct size fuse, if it blows again, there may be a problem
with the machine, seek professional help from an engineer.
8. Mains Lead:
Connect this to a suitable mains supply (230Vac).
9. Remote Control Socket:
For connection of the wireless receiver.
10. Menu Button:
used to browse the setup menu.
11. Up Button:
To adjust setting in the menu.
12. Down Button:
To adjust setting in the menu
13. Enter Button:
To enter sub menus in the main menu.
14. Eye Bolt:
Used to connect a safety wire.
Set Up Menu:
The setup menu is used to adjust the different parameters of the smoke machine.
The MENU button is used to navigate through the menu options.
1. Addr:
Press enter, use the up and down buttons to adjust the DMX address, then press enter to save
settings.
2. rENo:
Press enter to adjust the settings.
Here you have 5 settings: Gear, CH1, CH2, CH3, CH4, OFF, use the up and down buttons to choose one and
then press enter.
Gear:
Allows you to use all 4 buttons, A=25% fog output, B=50% Fog output, C=75% output, D=100% fog
output,
CH1,CH2,CH3,CH4
by choosing one of these you can choose what button activates the fog machine at full
output, this mode is useful when controlling multiple units from one controller. By selecting CH1 this will
mean that the smoke machine works from button A, CH2 button from B and so on.
NoFU:
Turns the low fluid function on and off. When the machine is low on fluid the display will flash. It is a
good ideal to leave this function ON (yes) as low fluid in the tank can damage the pump. Press enter and use
the up and down to select yes or no, then press enter again.
First Time Operation Panel Control:
• Before you start using this unit, please check there is no transportation damage, should there be any, please
do not use the device and contact your dealer immediately.
• The PFX1500S is designed to be used with water based fog liquid. NEVER OIL BASED.
• Put the smoke machine on a flat stable surface or hang from a suitable truss, make sure you use a safety
wire. Make sure no one can put any body part close to the heater output.
• Unscrew the Lid on the fluid bottle, fill up with a suitable fog liquid, do not to overfill. Screw the plastic cap
back on and ensure the tank never runs dry during operation.
• Connect the PFX1500S to a suitable mains supply (230Vac).
• There is a simple 4 button menu with an LCD display on the back of the unit. The 4 buttons control menu,
up, down and enter. When you first turn on the fog machine you will need to wait for around 3-5 minutes for
the heater to warm up, then you will get access to the controls.
• Press the menu button to scroll through options and use the up down buttons to make changes.
First Time Operation Wireless Controller:
• Before you start using this unit, please check there is no transportation damage, should there be any, please
do not use the device and contact your dealer immediately.
• The PFX1500S is designed to be used with water based fog liquid. NEVER OIL BASED.
• Put the fog machine on a flat stable surface or hang from a suitable truss, make sure you use a safety wire.
• Make sure no one can put any body part close to the heater output
• Unscrew the Lid on the fluid bottle, fill up with a suitable fog liquid, do not to overfill. Screw the plastic cap
back on and ensure the tank never runs dry during operation.
• Plug in the wireless receiver into the socket on the back labelled remote control.
• Connect the PFX1500S to a suitable mains supply (230Vac).
