ENGLISH
ENGLISH
6
7
CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where you purchased
your faucet.
2. When replacement parts are not available, please write or call Price
Pfister Consumer Service.
3.
Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all handles and decorative finishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage.
Use of
other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain porcelain or other similar substance
are not acceptable for public areas or commercial use. Installation
of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pfisterfaucets.com
• Installation Support
• Care and Warranty Information
6 HANDLE INSTALLATION
Place Valve Flange (
6A
) onto Handle Sleeve (
6B
). Place Base Seal (
6C
) on back of
Valve Flange (
6A
). With Valves in “Closed” position, insert Handle Sleeve (
6B
) onto
Valve Stems (
6D
). Secure Handles (
6E
) by rotating Valve Flange (
6A
) clockwise until
they sit
snug and flush to finished wall surface. Be sure that Valve Flange (
6A
) and
Handles (
6E
) are horizontally aligned. To remove Handles, reverse steps.
7 SPOUT BOBY INSTALLATION
Place Spout Flange (
7A
) over Spout Adapter (
7B
). Push Spout Flange (
7A
) by hand until
it is snug and flush to finished wall surface. Insert Spout Body (
7C
) onto Spout Adapter
(
7B
). Push Spout Body until it’s properly positioned and flush to Spout Flange (
7A
). Be
sure that both Spout Body (
7C
) and
Spout Flange (
7A
) are horizontally aligned.
From
below Spout Body (
7C
) tighten
Screw (
7D
) located at the bottom of spout as shown.
8 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
3
6A
6A
6E
6A
6E
6A
6A
6B
6B
6A
7A
7A
7D
7C
7A
7B
6C
6C
6D
7C
6E
6E
