ENGLISH
ENGLISH
13
12
11
12 SIDE SPRAY INSTALLATION
Insert Side Spray Hose (
12A
) through Hose Guide (
12B
).
From underneath sink, push Quick Connect Housing (
12C
), located on the end of the Spray
Hose (
12A
), firmly upward onto the receiving Tube (
12D
), until unable to push any further.
Pull down on the quick connect housing (
12C
). If the housing and the Inner Collet (
12E
)
separate slightly, but do not pull off the receiving Tube (
12D
), quick connect is secure.
When installing without side spray, a Plug (
12F
)
972-044
must be used and is to be
ordered separately.
13 WATER SUPPLY LINES
A.
Thread Inlet Connectors (
13A
) into Water Supply Lines (
13B
).
B.
Remove Protective Cap (
13F
). Gently separate hot and cold Faucet Inlets (
13C
),
approximately 1 in. (26 mm) apart. Connect Water Supply Lines (
13B
) onto Faucet Inlets
(
13C
). Hot water supply line goes to hot inlet fitting indicated by red tag.
C.
Insert Clip (
13D
) into Inlet Connector Holes (
13E
) to secure water supply lines, as
shown.
11 FAUCET INSTALLATION
Following manufacturer’s recommendations on use, apply plumber’s putty into putty
groove in Putty Ring (
11A
). Insert the faucet Supply Tubes (
11B
) through the center
hole of the sink (
11C
). Insert Hose Guide Shank (
11D
) through Flange Gasket (
11E
)
and into the sink hole (
11F
).
From underneath sink, secure the faucet by placing the Metal Washer (
11G
) and the
Long Nut (
7
/
16
Hex.) (
11H
) onto the Mounting Post (
11J
). Make sure that the bumps on
the Metal Washer (
11G
) are facing up. Tighten until the faucet is firmly connected to
the sink. Secure Hose Guide (
11D
) by screwing Plastic Locknuts (
11K
). Hand tighten.
Remove any excess putty from around the outside edge of Putty Ring (
11A
).
Do not over tighten!
Water Supply Lines are not included. Please consult
manufacturer and/or its instructions for the correct
method of installation of supply lines and fittings.
CAUTION:
Incorrect application of supply lines and fittings may
result in the failure or leak of the supply lines and fittings.
4
12A
12D
12E
12D
12C
12B
12A
12B
11B
11C
11D
11J
11E
11F
11K
11G
11H
11A
12C
1" Max.
(26 mm)
A
B
C
13A
13B
13C
13C
13C
13C
13A
13F
13B
HOT
COLD
13D
13E
13B
13D
13B
13A
OPTIONAL
(Must be ordered
separately)
12F
Содержание Brookwood 34 Series
Страница 17: ......