Pfaff powerquilter 1600, Руководство пользователя

Страница: 17 / 50

14 |
powerquilter
™
1600 Quilting Machine User’s Guide
Installing the Power Cord
Check that the On/Off switch is turned off
(the 0 setting). Plug the power cord into the top power
outlet on the back of the machine. Do not plug the
power cord into a power source at this time.
Installing the Foot Pedal
1. Plug in the foot pedal cord end into the foot pedal connector that is attached to the Stationary
Longarm Table.
2. Place the foot pedal under the table where operator can reach it from the front of the machine.
Installing the Thread Mast
1. Locate the two threaded holes on the left side of the
machine, near the top and towards the middle.
2. Remove the 2 screws with the 3mm hex wrench. Line
up the holes of the thread stand with the holes on the
machine and reinsert the screws.
3. Turn the thread stand until the eyelets are positioned
over the spool pins.
NOTE: The eyelets of the thread mast MUST be
centered over the spool pins. This ensures that the
cone of thread will not pull, turn or tilt, which will
cause thread tension problems.