Pfaff creative sensation pro II, Руководство пользователя, Страница: 33 / 166

2:11
A
D
C
B
1
Pr
epar
ations
&KDQJLQJWKHpresser foot
Remove presser foot
Press the presser foot downwards until it
disengages from the presser foot holder.
Attach presser foot
Line up the pins on the foot with the gap
underneath the presser foot holder. Press upwards
until the foot snaps into place.
You can also use the presser foot up/down buttons
to raise or lower the presser foot holder. Place the
presser foot under the presser foot holder, so that
the pins of the foot snap onto the presser foot holder
when lowered.
$WWDFKLQJWKH'\QDPLFVSULQJIRRW'
1. Disengage the IDT
™
system (A). Remove the
standard presser foot (B). Carefully loosen the
screw (C) until the cross-hole (D) is accessible.
2. Hold the foot in front of the needle. Turn the
hand wheel to lower the needle into the hole of
the foot and through the needle plate.
3. Turn the foot behind the needle screw (E) and
insert the pin of the foot into the cross-hole (D)
of the presser foot holder.
4. Push the foot into the hole as far as it will go
while tightening the screw (C).
To remove the embroidery foot loosen the screw
(C), squeeze the embroidery foot together and pull
it out to the right. Tighten the screw.
2
3
4
E
C