pewag levo hook LH5, Оригинальное руководство по эксплуатации

Страница: 26 / 80

26 pewag levo hook
EN
*Setting the transmitting signal (reach):
The radio control unit comes with a factory preset medium
transmitting signal (range). The transmitting signal may be
adjusted as follows:
Hold down the status query + hook lighting button
simultaneously until the battery status display on the remote
control begins to flash. Use the status query (+) and hook
lighting button (–) to adjust the transmitting signal.
If one green LED lights up, the transmitting signal is at the
weakest setting. If all LEDs light up, the transmitting signal
is at the strongest setting. The setting mode will terminate
automatically after a certain period. If the display ceases to
flash, the setting mode has terminated and the new setting
applies. Please note that a stronger transmitting signal will
shorten the lifespan of the integrated battery (button cell).
5.4 Connecting the
pewag levo hook with
the radio control unit
To operate the levo hook with the
radio control unit, you must first
connect the two devices. To do this,
proceed as follows:
1. Switch off the levo hook. Hold
down the on/off button until the
status display on the battery
begins to flash. The device is now
in connection mode.
2. On the radio control unit, press the
„status query“ button to perform
the connection process. When the
connection has been established
successfully, the status display
on the battery will give one long
flash. The radio control unit is
now connected. Section 2 may be
repeated for as many radio control
units as necessary.
3. To end the connection mode, press
the on/off button again.
This process must be completed
for every levo hook and every radio
control unit.
Please note that one radio control
unit may be connected with several
levo hooks (=hook network, see
chapter 5.5).
Several radio control units may also
be linked to one or several levo
hooks.
5.5 Hook network
• If one radio control unit is connected to several hooks,
a hook network is created. In this case, the radio control
Button Description
Open swivel hook
Press this button to open the
swivel hook
Close swivel hook
Press this button to close
the swivel hook
Hook lighting
(optional)
Press this button to activate/
deactivate the light module
that is integrated in the
levo hook. The light will
deactivate automatically
after a certain period of time
(depending on the setting).
Status query
Press this button to receive
a status notification for the
connected hooks.
Keylock
+
transmitting
signal*
A keylock function is
available for the radio
control to prevent accidental
activation of keys. To
lock/unlock the radio
control, briefly press the
lighting and status buttons
simultaneously.
Information
symbols
Description
levo hook battery
charge display
Shows the charge status of
the levo hook battery. If only
the red LED lights up, the
battery must be placed in
the charging station.
Status display
If this symbol lights up, the
test interval for the hook has
been exceeded or the hook
is malfunctioning. For more
information, please consult
the table in section 5.2.
Radio control
battery status
The battery that is integrated
in the radio control is weak
and should be exchanged
soon. For more information,
see chapter 9.7 Exchanging
the battery in the levo
remote radio control.
Radio control
keylock If this symbol lights up, the
keylock is activated.
Contact with lifting
device (optional)
The levo hook is in contact
with the lifting device, i.e.
the optionally integrated
magnetic module has
attracted the lifting eye.
fig. 5: Press for 3 seconds
fig. 6: Press button „status query“
fig. 7: Press to end