PEUGEOT 4008 2012, Руководство пользователя

Страница: 77 / 332

75
2
Access
Triggering of the alarm
This is indicated by sounding of the siren
and flashing of the direction indicators for
thirty seconds.
A message then appears in the instrument
panel screen while the siren is operating.
When the ignition is next switched on (ON
mode if your vehicle has the "Keyless Entry
and Starting" system), an audible signal sounds
four times to inform you that the alarm was
triggered during your absence.
Complete deactivation of
the alarm
) Switch off the ignition (OFF mode if
your vehicle has the "Keyless Entry and
Starting" system).
) Remove the key from the ignition switch,
if your vehicle does not have the "Keyless
Entry and Starting" system.
) Open the driver's door.
) Place the lighting control stalk in the " OFF "
position.
) Pull the wiper control stalk towards you and
hold.
After about ten seconds there is an audible
signal.
) When the audible signal stops, continue to
hold the wiper stalk pulled towards you and
press the remote control locking button.
You can completely deactivate the alarm
system. To do this, proceed as follows:
) The state of the system is then signalled to
you by the number of beeps:
One beep: the alarm system is completely
deactivated.
Two beeps: the alarm system is activated.
Each new press of the remote control
locking button changes the state of the
system.
It is possible to adjust the sensitivity
of the alarm sensor and to deactivate
the function via the colour screen
"Equipment" menu.