PEUGEOT 2002 607, Руководство пользователя

Страница: 138 / 158

15-07-2002
PRACTICAL INFORMATION
142
☞
Fold the jack by pressing at the
ends A and place it in one of the
four locations E underneath the
vehicle (the nearest one to the
wheel to be changed).
☞
Extend the jack, first by hand, pul-
ling the ends A then using wheel-
brace 1 and the extension 3.
☞
Remove a wheel bolt at the top
and fit the centralising tool 2 in its
place.
☞
Unscrew the other bolts and
remove the wheel.
Fitting a wheel
☞
Position the wheel using the cen-
tralising tool to assist you.
☞
Tighten the bolts by hand and
remove the centralising tool.
☞
Partly tighten the bolts using the
wheelbrace.
☞
Fold the jack and remove it.
☞
Fully tighten the bolts using the
wheelbrace.
☞
Replace the wheel trim.
☞
Put the tool holder back in posi-
tion. This helps to keep the boot
floor in its correct position, to pre-
vent any deformation of the floor
when loaded.
Tighten the spare wheel securing
strap to prevent noise and for your
safety in the event of impact.
For your safety, always
change the wheel:
– on level, stable, non-slippery
ground,
– with the handbrake applied,
– with first or reverse gear
engaged (position P for the
automatic gearbox),
– Never go underneath a vehicle
which is supported only by a
jack (use a ramp).
After changing the wheel:
– have the tightening of the bolts
and the tyre pressure checked
by a PEUGEOT dealer as soon
as possible.
– have the punctured wheel
repaired and refit it to the vehi-
cle as soon as possible.
Tyres fitted with the Tyre Under-
Inflation Detection System.
These wheels have a pressure
sensor. Have them repaired by a
PEUGEOT dealer.