12 1-800-732-2677
3. The mode switch is located
inside the transmitter and is
preset to mode A. Move the
switch to the center position
for mode B or to the right
position for mode AB (
4A
).
Once you have selected the
desired mode, replace the
battery door.
Inside
Battery
Door
Transmitter
Inside View
4A
Note: If you have selected mode AB you do not need to proceed with
programming the receiver in the next steps. Receiver Collars set to
mode A or mode B will each receive the radio signal from a Barrier
Transmitter set to mode AB.
4. To program the Receiver Collar to either mode A or mode B, press and
hold the DOWN (-) arrow button and then press the UP (+) arrow button
for approximately 5 seconds. Programming is complete when you hear
a series of three beeps from the Receiver Collar.
5. Once the Receiver Collar has been programmed, press the UP (+) arrow
button to turn the Barrier Transmitter ON. Check to make sure the black
bar(s) appear on the LCD screen indicating the mode you have selected
(
4B
) and reset the Barrier Transmitter to the desired range.
