1-800-732-2677
10
Step 2: Prepare the Receiver Collar
Your Receiver Collar comes with short Contact Points installed. Use the Long
Contact Points for pets with long or thick hair. Tighten the Contact Points using
the Contact Point Wrench (
2A
). Check tightness weekly.
To Insert and Remove the Receiver Collar Battery
Note: Do not install the battery while the Receiver Collar is on your pet.
This Receiver Collar utilizes a replaceable PetSafe
®
battery (RFA-67).
This unique battery is designed to make battery replacement easier and
increase water protection. Once you insert the battery and turn it to the lock
position, the unit will be turned ON.
To insert the battery, align the symbols on the battery (arrow) and Receiver Collar
(triangle) (
2B
). Use the edge of the Test Light Tool (
2B
) to turn the battery
clockwise until the arrow lines up with the lock symbol on the housing.
To remove the battery, turn the battery counter-clockwise using the edge of
the Test Light Tool (
2C
). DO NOT attempt to cut into or pry open the battery.
Be sure to discard the used battery properly.
Note: Before replacing the battery, discharge all power by holding the Mode Button
at least 30 seconds until the LED is no longer illuminated.
A replacement PetSafe
®
battery (RFA-67) can be found at many retailers.
Contact the Customer Care Center at 1-800-732-2677 or visit our web
site at www.petsafe.net to locate a retailer near you.
Turning the Receiver Collar ON
Press and hold the Mode Button continuously for 5 seconds (
2D
) The green or
red Receiver Indicator Light will turn ON for 5 seconds (
2E
) to indicate battery
status, followed by the red Receiver Indicator Light flashing the Static Correction
Level Settings.
Turning the Receiver Collar OFF
Press and hold the Mode Button continuously for 5 seconds. The red Receiver
Indicator Light will be ON during this time. The red Receiver Indicator Light will
then turn OFF and all Receiver Indicator Lights will stay OFF indicating that the
unit is turned OFF.
To Set the Static Correction Level
Read all steps before attempting to set the Static Correction Level.
1. Press the Mode Button and release (
2D) when the Receiver Indicator Light
illuminates Red (
2E).
2. The Receiver Indicator Light will emit a series of red flashes representing
the Static Correction Level.
3. Increase the Static Correction Level by pressing and releasing the Mode Button
within 5 seconds of the previous series of flashes.
The Static Correction levels increase in strength from 1 to 6. Pushing the Mode Button while the Receiver
Collar is on level 6 will cause the Receiver Collar to revert to level 1. Refer to the Function and Response
Table to choose the Static Correction level that best fits your pet.
2A
2C
2B
Risk of explosion if batteries are replaced by an incorrect type. Do not short
circuit, mix old and new batteries, dispose of in fire, or expose to water.
When batteries are stored or disposed, they must be protected from shorting.
Dispose of used batteries properly.
2E
2D
Mode
Button
Содержание PIF00-15001
Страница 2: ...1 800 732 2677 2...
Страница 27: ...www petsafe net 27...
