petsafe.com
11
The feeder is not dispensing
the programmed meal
amount or any food at all.
(continued)
• If the conveyor was removed for cleaning, it may not have
been aligned properly before being installed (see “Reassemble
the Feeder” on page 8 for detailed instructions.)
• Make sure the conveyor is primed anytime the food gets low
or you refill with food for correct meal sizes to dispense (see
“Setup and Assemble Feeder” on page 5 or “Reassemble the
Feeder” on page 8 for detailed instructions).
The food is dispensing
slowly.
• Check if Slow Feed mode is turned on in the app. Slow Feed
applies to all meals.
Customer Care International
USA & Canada - Tel: 800-732-2677 – Monday - Friday 8 AM - 8 PM / Saturday 9 AM – 5 PM
Australia - Tel: 1800 786 608 – Monday - Friday 8:30 AM - 5 PM
New Zealand - Tel: 0800 543 054 – Monday - Friday 10:30 AM - 7 PM
Terms of Use and Limitation of Liability
1)
Terms of Use:
This Product is offered to you conditioned upon your acceptance without modification of the
terms, conditions and notices contained herein. Usage of this Product implies acceptance of all such terms,
conditions, and notices.
2)
Proper Use:
This Product is designed as a system for automatic dispensing of dry pet food. The specific
temperament of your pet may not work with this Product. If you are unsure whether this is appropriate for your
pet, please consult your veterinarian, certified trainer or contact our Customer Care Center or visit our website at
www.petsafe.com
. Proper use includes reviewing the entire Operating Guide for your product and any specific
Caution statements.
3)
No Unlawful or Prohibited Use:
This Product is designed for use with pets only. This device is not intended
to harm, injure, or provoke. Using this product in a way that is not intended could result in violation of Federal,
State or local laws.
4)
Limitation of Liability:
In no event shall Radio Systems Corporation be liable for any direct, indirect, punitive,
incidental, special or consequential damages, or any damages whatsoever arising out of or connected with the
use or misuse of this Product. Buyer assumes all risks and liability from the use of this Product.
5)
Modification of Terms and Conditions:
Radio Systems Corporation reserves the right to change the terms,
conditions and notices under which this Product is offered.
Compliance
FCC/Canada
This Class B digital apparatus complies with Canadian ICES-003. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equipment is operated in a residential
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction guide, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a practical installation. If this equipment causes harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Relocate the interfered receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different to that to which the receiver is connected.
• Contact the Customer Care 1 (800) 732-2677.
This device complies with Industry Canada Rules. This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Unauthorized changes or modifications to the equipment, not approved by Radio Systems Corporation, could result
in not meeting compliance with FCC regulations and could void the user’s authority to operate the equipment.
Australia
- This device complies with the applicable EMC requirements specified by the ACMA (Australian
Communications and Media Authority).
CE
- This equipment has been tested and found to comply with relevant EU Electromagnetic Compatibility, Low
Voltage and R&TTE Directives. Before using this equipment outside the EU countries, check with the relevant local
R&TTE authority. Unauthorized changes or modifications to the equipment that are not approved by Radio Systems
Corporation are in violation of EU R&TTE regulations, could void the user’s authority to operate the equipment, and
void the warranty. The Declaration of Conformity can be found at: http://www.petsafe.net/customercare/eu_docs.php.
