Charge the Training Collar and Remote
Excessive charging can shorten battery life. Only charge your remote or collar when the batteries are low.
1. Plug in and fully charge the remote and receiver collar. This can take up to 5
hours. Subsequent charging will take 2-3 hours.
2. When fully charged, the green LED on the collar will turn off, and the battery
meter on the remote will stop cycling and appear full.
3. When the collar and remote are charged, replace their rubber covers. This will
keep the debris out of the charging ports. The remote and collar are waterproof
up to 3 feet.
To Turn the Training Collar On
Press and hold the on/off button until you hear a low to high beep and the green
LED appears, and then release.
NOTE:
The handheld remote is always on, and the display will appear when any
button is pressed.
To Turn the Training Collar Off
Press and hold the on/off button until the collar beeps high to low, and then release.
The red LED will be illuminated during the button press and will turn off when the
collar turns off.
Quick Tip: When you’re not using the collar, you’ll want to turn it off to
increase the battery life.
Test the Remote Trainer
We recommend you experience firsthand how the static stimulation functions. Always begin at the lowest level, and
increase the intensity up to your personal comfort level.
1. Place one finger over both contact points of the training collar.
2. Hold your remote approximately 2 ft. from the training collar. Starting at level 0, press the vibration button
continuously for 1 to 2 seconds. You should feel continuous vibration. There is only one level of vibration.
3. Increase the level to 1 for static stimulation. At this level you may not feel the stimulation.
NOTE:
Continuous
stimulation will transmit for no more than 10 continuous seconds. To reactivate, release and repress the button.
4. Increase the level until the sensation begins to feel uncomfortable.
A. Tone Symbol:
Delivers a tone with non-adjustable volume
to the collar.
B. Vibration Symbol:
Sends 1 non-adjustable level of
vibration stimulation to the collar.
C. Static Symbol:
Delivers up to 15 levels of static stimulation to
the collar that can be adjusted with the side button.
D. Lock Symbol:
Indicates static stimulation levels 8-15
are locked or unlocked.The default for the remote is set to
"unlocked". This can be used as a safety feature to prevent
going above level 7 during training.
E. Battery Indicator:
Indicates the amount of battery
remaining in the remote.
Pairing a Second Collar with the Remote
Note: available on the 300 Yard trainer or higher.
1. Press and hold the Dog 1/2 button on the remote for approximately 3 seconds. Both Dog 1 and Dog 2 icons
will appear on the display.
2. Press and hold the on/off button on the collar.
3. After approximately 5 seconds the LED on the collar will turn off indicating that it is ready for pairing.
4. Press either of the top 2 stimulation buttons on the remote. The collar LED will blink 5 time to indicate successful pairing.
On/Off
Button
Charging
Port
Level Adjuster
0=Vibration
1-15=Static
A. Tone
D. Lock
B. Vibration/
C. Static
E. Battery
Indicator
Dog 1
*
Dog 2
Dog 1/2 function is available on the 300 Yard
Remote Trainer and higher.
*
