www.petsafe.net
11
Reset the Receiver Collar
To reset the Receiver Collar to work with a new Remote Transmitter or to reprogram a
new Receiver Collar to work with your existing Remote Transmitter:
1. Turn the Receiver Collar off.
2. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Receiver Collar beeps 5 times.
3. Continue to hold the On/Off button until the Receiver Indicator Light has turned off.
4. Press and hold the Upper Button on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 0.5-1 m from each
other before this occurs. Once the Receiver Indicator Light has fl ashed 5 times, the
Receiver Collar has been reset. If the Receiver Indicator Light does not fl ash 5 times,
start again and repeat the process.
_____________________________________________________________
Program the Receiver Collar for Two or
Three-Dog Operation
With the Transmitter set to Mode 3 or 4, PetSafe
®
Receiver Collars can be set to
respond to the upper, lower, or side Remote Transmitter buttons. Add-A-Dog
™
receiver(s) must be purchased to train additional dogs.
1. Program the Remote Transmitter to Mode 3 or 4.
2. Program the fi rst Receiver Collar.
A.
Turn the Receiver Collar off.
B.
Press and hold the On/Off Button. The Receiver Indicator Light will come on,
then turn off in 4-5 seconds. If the On/Off Button is released too early, the Receiver
Indicator Light will begin its normal fl ashing. If this occurs, start over and repeat the
process.
C.
After the Receiver Indicator Light has turned off, release the On/Off Button.
D.
Press and hold the
Upper Button
on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 0.5-1 m from each
other. If the Receiver Indicator Light does not fl ash 5 times, start over and repeat the
process.
3. Program the second Receiver Collar using
A.
through
D.
above, but using the
Lower
Button
in place of the Upper Button.
4. Program the third Receiver Collar using
A.
through
D.
above, but using the
Side
Button
in place of the Upper Button.
Step
6
Step
7
