5
not be worn for more than 12 hours out of every 24-hour period. Leaving the collar on
Charging the Collar
Excessive charging can shorten battery life. Only charge the collar when you see the low battery light.
1.
Lift the cover protecting the charging port and connect the charger.
2.
Plug the charger into a standard wall outlet. The green LED will appear.
3.
Recharges take no more than 5 hours. Although your bark collar should be partially charged,
you’ll
want
to fully charge it before using it for the first time. The green LED will turn off after charging is complete.
4.
When the bark collar is charged, replace the rubber cover.
To Turn the Collar On
Press and hold the power button (
D
) until you hear a low to high beep
and the green LED appears, and then release. The green LED will flash
once every 5 seconds.
To Turn the Collar Off
Press and hold the power button until the bark collar beeps high to low,
and then release. The red LED will be illuminated during the button
press and will turn off when the bark collar turns off.
Quick Tip: When
you’re
not using the collar,
you’ll
want to turn it off.
This will increase the battery life.
LED Function
The two color LED indicates the battery level. When the battery is low, the red LED will blink 3 times every 5
seconds. When it is fully discharged, no LED will flash. When the collar is charged, the green LED will flash
once every 5 seconds.
Temperament Learning
Temperament Learning tracks the number of corrections needed to substantially reduce (and in most cases)
eliminate the number of nuisance barks. The collar starts at the lowest correction level and increases
the intensity with each successive bark until the barking stops. This correction level becomes the starting
level the next time the dog barks. Once your dog has learned to reduce this barking, the initial warning
corrections are automatically reduced.
NOTE: As a built-in safety feature, if your dog barks 15 times or more within an 80 second period, the bark
control collar will automatically shut off for 3 minutes.
Reset the Correction Level
1.
Press and release the on/off button to turn ON the collar. Wait 5-10 seconds.
2.
Press and hold the on/off button for 10 seconds. The green LED will flash 5 times.
3.
Release the on/off button to turn the bark control collar OFF.
4.
The correction level will then return to 1.
D
Do not shave the
pet’s
neck as this may increase the risk of skin irritation. The collar should
too long could lead to skin irritation.
