Petsafe PBC17-14135, Руководство по эксплуатации

Страница: 7 / 84

www.petsafe.net 7
DE
IT
ES
NL
FR
EN
Key Definitions
Spray Nozzle:
Where the
spray ejects when your dog’s bark
is detected.
Refill Port:
Where the spray
is refilled.
Battery Cover:
Where the 6-volt
Alkaline Battery is placed.
Microphone:
Detects the sound of
your dog’s bark.
ON (l) and OFF (O) Switch: Turns the Bark Control Collar ON (l) and OFF (O).
STEP 1
Fit the Bark Control Collar
Important:
The proper fit and placement of your Bark Control
Collar is important for effective operation.
To assure a proper fit, please follow these steps:
1. Make sure that the Bark Control Collar is turned OFF (O).
2. Start with your dog standing comfortably (
A
).
3. Place the Bark Control Collar on your dog’s neck close to the
ears. Centre the Microphone on your dog’s
neck, touching the skin (
B
). Make sure the
PetSafe
®
logo in the front of the Bark Control
Collar is upright and the Spray Nozzle is pointed
toward your dog’s snout.
4. Check the tightness of the Bark Control Collar
by inserting one finger between the nylon collar
and your dog’s neck (
C
). The fit should be snug
but not constricting.
5. Allow your dog to wear the Bark Control
Collar for several minutes, then recheck the fit.
Check the fit again as your dog becomes more
comfortable with the Bark Control Collar.
6. Trim the nylon collar as follows (
D
):
a. Mark the desired length of the nylon collar with a pen. Allow for growth if your dog
is young or grows a thick winter coat.
Refill Port Spray Nozzle
Battery
Cover
Microphone
ON (I) /OFF (O) Switch
(Bottom View)
B
C
YES
NO
A
D
b. Remove the Bark Control Collar from your
dog and cut off the excess.
c. Before placing the Bark Control Collar back
onto your dog, seal the edge of the cut
nylon collar by applying a flame along the
frayed edge.
The Bark Control Collar should not be worn for more than 12 hours out of
every 24-hour period. Leaving the Bark Control Collar on too long could
lead to skin irritation. Please refer to page 3 for additional information.
STEP 2
Prepare the Bark Control Collar
To Insert and Remove the Battery
Note: Do not install the battery while the Bark Control Collar is on your dog.
1. Slide off the Battery Cover.
2. Insert the 6-volt Alkaline Battery. Keep the polarity in mind (+ and -).
3. Slide the Battery Cover back on.
A replacement battery (6-volt alkaline) can be found at many retailers. Contact the
Customer Care Centre or visit our web site to locate a retailer near you.
Battery Life
Average battery life is 2 to 4 months, depending on how often your dog barks. However,
due to greater use during your dog’s training, your first battery may not last as long as
replacement batteries. Turn OFF (O) the Bark Control Collar when not in use.